Home Growers Guide Products Dosage Calculator Buy | Profile | Partners Downloads Sitemap Contact

Tel/Fax (+61) 8 9314 7595

sales@flairform.com


General daily system checklist
 

Plants

- Check top and underside of foliage for likely signs of disease, insects or nutrient deficiency. Also check other vulnerable areas such as buds and the stem base.

- Cut any dead, dying or diseased foliage and promptly remove from the growing area.

- Conduct any necessary shaping or training of foliage.

- Ensure foliage is properly supported (via string, netting or stakes), and support mechanism is not damaging the stem or foliage.

- Ensure foliage is not being unduly shaded by other plants.

- Check roots/medium at various points for signs of disease i.e. brown roots, insects or over/under watering. Confirm that roots are not “root-bound”.


Nutrient system

- Ensure nutrient schedule appropriate for the current phase of growth.

- Ensure feed frequency (pump timer) and volume is appropriate for the current conditions – especially during heatwaves.

- Check pump and timer are working properly.

- Check feed outlets (drippers) are not blocked.

- Check nutrient/water/pump filters and clean if necessary.

- Check for plumbing leaks.

- Check nutrient is not pooling in trays/channels/pots.

- Check drainage outlets are not being blocked by roots.

- Empty the run-to-waste collection container.

- Check/adjust EC. For recirculating systems, add top-up water if needed.

- Apply routine additives (e.g. disinfectants) as required.

- Check/adjust pH between 5.0 and 6.5. For recirculating systems, set pH generally no higher than 6.0.

- Check nutrient temperature is between 20-25OC (68-77OF).

- Recirculating systems: Discard, flush and replace old nutrient every 7-14 days. Do every 7 days, or as required, if using hard/salty water.

- Run-to-waste systems: Flush medium at least every 7 days (p61).

 

Lighting

- Check for signs of leaf burn on foliage closest to the lamp.

- Check for signs of insufficient light e.g. sparse foliage, spindly branches. A light meter can be used to verify if lighting is the cause of these symptoms.

- Check timer is correctly programmed for the given phase of growth.

- Check temperature of electrical connections/plugs for signs of arcing or burning.

- Use a light meter periodically to check if lights are working to specification.


Ventilation

- Check maximum and minimum data on thermometers and hygrometers. Ensure both day (~25OC/77OF) and night temperature (15-20OC / 59-68OF) and humidity (50-70%) is appropriate.

- Ensure oscillating fans are covering all foliage, especially those closest to the lamp.

- Check temperature of electrical connections/ plugs for signs of arcing or burning.

- Check air filters and clean if necessary.


General

- Keep surfaces clean from dust, dirt and spillages. Remove any waste material from the growing area.

- Conduct any necessary foliar spraying.
 

Download System Checklist as PDF

[Growers Guide Main Index]

• Home • Growers Guide • Dosage Calculator • Products • Buy • Downloads • Profile • Partners • Links • Sitemap • Contact •

 

Copyright ©2002-2009  FlairForm  All rights reserved.

Development by Website Concepts
Web Development Website Concepts.
This page was last updated 27 January, 2012